Blog

10 Helpful Roofing Tips

Leaks are common in designated locations on the roof. To repair them safely from commercial contractor, here are ten helpful tips that you can use:

  1. Prioritize your safety

Do not get too focused on repairing a leak and forget about the dangers involved. Rushing to eliminate leaks without a proper plan may affect your health. For instance, doing any repairs when it’s raining, or when the hole has been covered in snow or ice can land you in a hospital bed. Instead of fixing leaks temporarily, take your time, and find a solution that will last.

  1. Get the location right

Pour water on the roof using a hosepipe to identify the exact location of the leak. Avoid doing this during the winter season. It is not safe to spray the roof with water when it’s frozen.

  1. Clean the gutters

Blocked gutters contribute to the retention of water on the roof during the rainy season. Failure to clean the gutters will increase the number of leaks. As a result, your roof will experience a lot of damage.

  1. Be cautious

Roof repair exposes your body to postures that are neither safe nor comfortable. To avoid slipping, make sure that you get the right pair of shoes, such as rubbers. Strap yourself well and have someone on standby in case you need to be assisted.

  1. Inspect roof valleys

Also known as ridges, valleys refer to points where two roofs intersect. Leaks are common at these intersections because this is where water from the roof collects when it rains.

  1. Prevent ice from building up on the roof

During the cold and rainy seasons, you are likely to find ice deposits on the membranes, gutters, and shingles of your roof. When the ice builds up beyond the wall line, it may start to drip inside your house. You can prevent this by installing ice shields and a drip edge on the roof, and putting measures that ensure proper ventilation.

  1. Install rubber boots

Roof boots shield your vent pipes from debris and water. Installing them at the roof fence prevents leaks that may arise from flashing, skylights, ice damping, and roofing. In case your roof boots dry up, get a replacement from any hardware store within your area. To install a new boot, remove some shingles, add some fresh tar under them and place it on top before returning the shingles in place.

  1. Check roofing materials out 

Before embarking on any roof repair exercise, confirm that all the materials are in good condition. Shingles, for instance, may crack as soon as you nail them down due to being faulty. If you proceed to install them as they are, you will continue experiencing leaks. Drive the nails deep into the roof to prevent them from pushing back up.

  1. Prevent dry rot

Dry rot is a kind of wood decay caused by poor ventilation. It is not caused by water. When decay is present, and you repair your roof right in the middle, it may sag in and press down the shingles, making them weak. Eventually, leaks will develop. To prevent your roof from dry rot, install ridge vents alongside the soffit vent. Drill some holes on the soffit vent in a way that allows cold air to enter from the bottom and hot air to exit from the top.

  1. Seal all the leaks

Not being able to identify leaking points on your roof can be frustrating. To eliminate all the leaks effectively, concentrate on one area of the roof at a time.

Leave a Reply

Your email address will not be published. Required fields are marked *